Problem with Glow Boy, Acutron II

[2matter]

Hi, I just joined the forum to get help from this knowledgeable community . I have a Glow Boy HGB3 Pellet stove I have had for about 5 or 6 years and it just shut down today, I restarted it and it ignites and feeds, but there are no feed or fan led's lit, it just seems to be at a set feed and fan. The ignitor light is on and the auger light comes on as the auger cycles. It will continue like that for a while and eventually shut itself off but leaves a little burning pellets. Then if I push the off button it will cycle down the rest of the way and shut off.
I have a surge protector on it, I have unplugged it and no change. I tried cycling through the 3 modes by holding down the off button and it will cycle but no change. When I do that, I set it to manual mode as I don't have a thermostat.
I am guessing it needs a new control board and the replacement for the Acutron 2 is the Acutron 4, but at $400 I am not crazy about just guessing. Hopefully you can help and thanks in advance!

 

[Don2222]

Hello
The first thing to do is check all the safety switches that stop power for a safety shutdown .
Check the vacuum switch , the high limit snap disc and the low limit snap disc.
The high limit and vacuum switches can be bypassed one at a time by disconnecting the wires and connecting them together. Be careful not to let them touch the metal body of the stove so they do not short out.
I am not sure what the Accutron II will do if there is a bad safety switch it could be similar to the Accutron IV
This is the Accutron IV safety switch error, see pics and video below. Click on this link below.

Thread 'Pelpro Accutron IV heat level light blinks red when starting but then goes out and stove quits!'

Jan 17, 2025

Hello
Has anyone seen this issue?
Pelpro Accutron IV heat level light blinks red when starting but then goes out and stove shuts off!
This error happened with a new control panel set in manual mode. That is heat level lights 1 & 4 blinking together when checking the mode of operation.
It seems like the panel is working properly but unfortunately it does not have well defined errors after it quits like many other brand stoves. On other stoves the heat level blinks with the error. Example if the 2 light blinks that is a vacuum error.
Here is a good video of setting the panel to manual mode...

• Don2222
• Replies: 0
• Forum: The Pellet Mill - Pellet and Multifuel Stoves

•