Hi! I need some advice. I am setting up a new Wood Stove install. The challenge is shallow roof pitch so owner doesn't want anything to go through the roof. There are 2 levels of the house a taller section with a 14' ceiling and the other part w 10' ceiling. the stove is going in the `14 section.
option 1. Ideally would like to go straight up from stove into ceiling support box and then hard turn and go out side wall of 14 ft section over the 10ft section and up from there, but haven't seen anywhere a 90 or close to 90 turn in the ceiling, so i guess that's not done.
option 2. have a long stove pipe on the inside that has to go up but also a fair amount horizontally to clear the rise of the 10ft roof truss and the out through normal wall thimble. but on outside need to kick out to clear the 2ft roof overhang.
is the resistance to 90 turns fear of creosote? I see them a lot on the inside. and i guess a wall thimble has one tee.
thanks!
option 1. Ideally would like to go straight up from stove into ceiling support box and then hard turn and go out side wall of 14 ft section over the 10ft section and up from there, but haven't seen anywhere a 90 or close to 90 turn in the ceiling, so i guess that's not done.
option 2. have a long stove pipe on the inside that has to go up but also a fair amount horizontally to clear the rise of the 10ft roof truss and the out through normal wall thimble. but on outside need to kick out to clear the 2ft roof overhang.
is the resistance to 90 turns fear of creosote? I see them a lot on the inside. and i guess a wall thimble has one tee.
thanks!
