We are UK based and have found very little experience/assistance available here for pellet stoves as most people dismiss them as a form of heating and hope therefore someone with experience may be able to answer our question.
We have a Venezia Hydro which circulates water through a couple of heat exchangers which in turn disseminates warm air around the house. Currently the pump on the stove switches off at 50 degrees which means there is a lot of warmth in the system which just sits rather than circulating down to say 40 degrees. Is there any way of modifying the factory pre-set of 50 degrees? If the pump ran for longer, we would get more distribution of warmth throughout the whole house rather than just around the stove and in the location of the heat exchangers.
We have seen previous posts with clear instructions for changing the Threshold value on such stoves and hope someone may have an answer which would help us.
Thank you all.
We have a Venezia Hydro which circulates water through a couple of heat exchangers which in turn disseminates warm air around the house. Currently the pump on the stove switches off at 50 degrees which means there is a lot of warmth in the system which just sits rather than circulating down to say 40 degrees. Is there any way of modifying the factory pre-set of 50 degrees? If the pump ran for longer, we would get more distribution of warmth throughout the whole house rather than just around the stove and in the location of the heat exchangers.
We have seen previous posts with clear instructions for changing the Threshold value on such stoves and hope someone may have an answer which would help us.
Thank you all.
