McCulloch Super Pro 125C arrived today.....I'm done with CAD for a while haha

[Thistle]

Repainted clutch cover last night,vintage late '60's 30" roller nose bar (check out part of the original sticker that's still on it - General Bar of Oregon went out of business years ago....),new .404 skip chain & outer "hadstone" felling dawg arrived via UPS yesterday.Didnt have time to install that,but hopefully will this weekend.

No worries about the spot or two of paint on that muffler & bar nuts.....they'll get worn off pretty soon.

NOS air filter & recoil spring should arrive by then,the puzzle is almost complete....

 

[Thistle]

All repainted,any needed parts replaced.Tuned the carb,idles great now with quick throttle response.
Has that distinct loud exhaust "crackle" sound that very large vintage Mac's are famous for.....


One of these days I'll have a vid of it actually cutting a big round.

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

 

[Thistle]

 

[Thistle]

"New" mega-large outer "hadstone" falling spike installed a few weeks back,repainted over the weekend.Made a few cuts in past 2 weeks,not even ripping a 22" diameter Honey Locust would slow this beast down.Didnt even bear down on those spikes,that square chisel full skip .404 chain just grabbed hold & took off....

Muffler cover repainted & installed yesterday.Missing one of the factory 10-32 x 3/4" heat treated machine screws,I can grab one for a buck or so at neighborhood hardware store anytime.This is normal condition for this very rare part.You're lucky to see 10% of these saws with one still intact.They took all kinds of abuse - from getting smacked with a limb to bouncing around in the back of the truck.Normally are all busted & gone.This will do until I locate a NOS one someday.

 

[smokinj]

Looks awesome........