K- Stove similar to a Nemaxx P6 not staying lit

[DanteDomino1]

Hello, any suggestions as to what’s happening here?

Switch the machine on it feeds the pellets into the bowl fine, igniter heats up fine. Blower fan works, gives strong flame and exhaust fan is on. It gets up to decent temperature but won’t feed anymore pellets after the initial start cycle has completed. Stays in lighting mode on control unit but eventually fire goes out as no new pellets are in the burn basket.
Codes seem were E2 or also one time just turned off without error code after trying again.

Thank you, typical of course right before the holidays!

 

[Ssyko]

Sounds like the proof of fire snap disc has failed. Turn off stove, find correct disc and pull the wires off and connect them. Insulate the 2 wires, they can not touch the stove!! Turn on stove and see if that lets it run normally.