Ssyko
Minister of Fire
Combustion blower should come on when stove is turned on and stay on. You my have a problem with the control board.
Enviro Empress won't start/light-Need help/suggestions
- Thread starter The Coopers
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil. -
Super Cedar firestarters 30% discount Use code Hearth2024 Click here
When he cleaned it did he remove the burn pot?
were the to parts put back correctly Pot with big lip forward?
were the to parts put back correctly Pot with big lip forward?
JRemington
Minister of Fire
I’d pull the combustion blower, clean it and hook it directly to power and watch it run. They can kick on and off when they go bad.
JRemington
Minister of Fire
Apologizes! Yes, we replaced the convection blower and i meant to say convection blower (that was replaced) is not spinning again.
Combustion blower works just fine.
Upon shutdown, convection blower kicks on and starts to spin.
Combustion blower works just fine.
Upon shutdown, convection blower kicks on and starts to spin.
JRemington
Minister of Fire
JRemington
Minister of Fire
On the same side as the combustion blower, up on the back of the chamber, under the hopper. It looks like the high limit sensor only it doesn’t have a reset. And it says 160 on it. Jump them and I think your fan will run.
fan kicked on with your suggestion but the stove didn’t not fire up.
safe to say to replace the part?
JRemington
Minister of Fire
You can replace the switch but you can leave it jumped until you get the new one.
Similar threads
