start up problems eko 40 1000 gallons pressurized storage

[fishman]

On my first fire my control panel showed an e-1 message and the fan wood not kick on the pump was running.I only put a small amount of wood in for the test . After a while of burning
control panel showed e-1 and e-3 and fan never kicked on.Then i opened the air bleeder screw
on top of the air separator and lot air in lines could that be the problem.

 

[Dave T]

There is another post describing the same E-1 code and the solution was to unplug the EKO a few seconds then plug it back in and turn the EKO off then on again..Search E-1 code,Good luck Dave

 

[fishman]

thanks sounds to good to be true i will try again

 

[Vtgent49]

your basic reboot, lol. Wiggle wires first, then reboot. Same reccomendation for any high tech stuff. Then ask for help.

 

[Tony H]

Can't see where this would help but isn't E-1 an error on the pitcher