Lots of knowledge on this forum I’ve been using for years. Learned a lot. Finally stumped and have to post.
Ashby P is about 10 years old. The end of last year it started throwing a POF error with a FULL pot of pellets, while running in thermostat mode. It would run for awhile before the error.
It is clean.
Since I have replaced burn pot, bottom versa grate, igniter, and POF switch. First thought was that the stove was getting too much air being the pot and bottom were in bad shape. Still threw error, also with a full pot of pellets. Changed igniter which by ohms seemed bad. POF error again but now with an empty pot. Lastly changed POF and again POF error with an empty pot.
So….checked auger function. Seems ok
Yesterday decided to run it in manual to see if it will throw an error. Nothing yet. Runs fine in manual so far.
Stumped.
Ashby P is about 10 years old. The end of last year it started throwing a POF error with a FULL pot of pellets, while running in thermostat mode. It would run for awhile before the error.
It is clean.
Since I have replaced burn pot, bottom versa grate, igniter, and POF switch. First thought was that the stove was getting too much air being the pot and bottom were in bad shape. Still threw error, also with a full pot of pellets. Changed igniter which by ohms seemed bad. POF error again but now with an empty pot. Lastly changed POF and again POF error with an empty pot.
So….checked auger function. Seems ok
Yesterday decided to run it in manual to see if it will throw an error. Nothing yet. Runs fine in manual so far.
Stumped.
