How do I enter the service parameters to feform a circ pump test and fan out put test? I want to run the circ and fan before I light it for the first time.
Thank you,
Rob
Thank you,
Rob
RK2001ua controller test mode
- Thread starter taxidermist
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil. -
Super Cedar firestarters 30% discount Use code Hearth2024 Click here
- Status
Rob,
I believe you have to be in the STOP mode. Then get into the service parameters by holding the OK button down for a few seconds. Scroll through, and once you get past the "PROD" facotry settings, you will see 3 additional parameters "out P, out (some Polish symbol - upside down U) and outr", for the Pump, Fans and Additional Output. Hit OK to toggle them on or off. You won't find these three options if you are in the regular On mode.
I believe you have to be in the STOP mode. Then get into the service parameters by holding the OK button down for a few seconds. Scroll through, and once you get past the "PROD" facotry settings, you will see 3 additional parameters "out P, out (some Polish symbol - upside down U) and outr", for the Pump, Fans and Additional Output. Hit OK to toggle them on or off. You won't find these three options if you are in the regular On mode.
- Status