I have a profile 30 insert pellet stove and have had it for 13 years. When I went to start the stove i noticed the convection fan did not seem to be on high. So I cleaned the stove completely and both blower motor and convection motor. I but the stove back together and the convection fan still is maybe on medium speed. So I unpluged the motor while the stove was running and plugged the motor directly into 120volt outlet and the motor went on high speed. Then I plugged it back into the stove wire harness and it went back down to medium speed instead of high. I put a volt meter on the two wires and I am only getting 108volts. Then if I unplug the motor and put the volt meter on the wires going to the motor I get 120volts without the motor plugged in. Any ideas what might be wrong? Would this be a bad control board?
Thanks
Thanks