My Quadrafire CB1200 will only feed pellets if I reset or take wire off of Snap Disk #2. I have tried to jump around it but that doesn’t work either. Red light is on and calling for heat. Amy suggestions?
Pellet feed issues
- Thread starter Ewaller
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil. -
Super Cedar firestarters 30% discount Use code Hearth2024 Click here
From your manual
. Snap Disc #2 (Thermostat Override) 200°FSnap Disc #2 is also located on the right side of the appliance between snap disc #1 and the convection blower. There are 2 yellow wires connected to it. This snap disc will turn off the feed system, which will turn off the appliance if an overfire condition should occur or if the convection blower should fail to operate.
. Snap Disc #2 (Thermostat Override) 200°FSnap Disc #2 is also located on the right side of the appliance between snap disc #1 and the convection blower. There are 2 yellow wires connected to it. This snap disc will turn off the feed system, which will turn off the appliance if an overfire condition should occur or if the convection blower should fail to operate.
Similar threads
