Hello, I came across this site 4-5 months ago accidently. Lots of good information here, and I have learned alot since. By reading different post I learned I needed to get rid of the old pre - epa stove and update to a new epa stove. So in the middle of December after much research, I purchased a new Blaze King Princess Parlor. This stove will be sitting in a family room of 480 sq. ft. with 9 ft. ceilings. The house is 2,900 sq.ft., two story, built in 1965. This will be installed on the hearth where the old stove was sitting and exiting up a masonry chimney through a 6" Duraliner s.s. liner. Where the flue opening is on the new stove I will be installing a couple of 45's and piping to make up for the offset. Without checking or much research, I ordered online, Dura Vent DVL 6" double wall black stove pipe. The problem I am having is the transition from the DVL stove pipe to the 6" Duraliner. Do I need to order something else to connect these two? Do I need to send the DVL back and go with all Duraliner to the stove? I do know the Duraliner stove attachment will not fit over the Princess's flue collar. The attachment is to small. Any suggestions is appreciated. Thanks, Jerry