I have a new wood stove going on. It's a corner install and I have two issues I need advice on:
1) the attick truss beam is dead in the middle of where i need my stove pipe. If I move the stove out, it's to far into the room. I cant move it back because of wall clearance. Im thinking im going to have to do the ugly 2x 45 degree to angle it off center of the stove. Any suggestions or advice here? Its going to look odd if i angle it in the room. I can't go outside and then up because I only have 12" eve I would have to go through. Im also concerned about a 90 degree to go out if i did it tha way.
2) i have the seam of a gable on my roof right over where the stove pipe would potentiall come out. Im going to have to also have 2x 45 degree angle it up hill from the gable to clear that. is there a problem having so many angles in a situation like this?
1) the attick truss beam is dead in the middle of where i need my stove pipe. If I move the stove out, it's to far into the room. I cant move it back because of wall clearance. Im thinking im going to have to do the ugly 2x 45 degree to angle it off center of the stove. Any suggestions or advice here? Its going to look odd if i angle it in the room. I can't go outside and then up because I only have 12" eve I would have to go through. Im also concerned about a 90 degree to go out if i did it tha way.
2) i have the seam of a gable on my roof right over where the stove pipe would potentiall come out. Im going to have to also have 2x 45 degree angle it up hill from the gable to clear that. is there a problem having so many angles in a situation like this?