Hello all, I'm not sure where to start. I tried searching the internet and tried all the basic stuff I could find and I'm hoping someone here can help me get the stove running again. Basically when I plug it in the blower turns on and it goes through the 3 second phase then when I flip the switch on the control panel nothing happens. No lights no sounds. The two fuses on the control panel are intact and the stove was running at the end of last season. I cleaned the hopper out completely and emptied the auger the best I could with a shop vac and some agitation and coat hanger . Middle of last season it would turn on and light up but then through an error which after cleaning the auger out it started and ran fine for the remainder of the season. This time since the panel isn't even turning on there's no lights to diagnose. Thanks ahead for any help. I just loaded a ton of pellets into my garage for the winter and I'm hoping to use them.
Napoleon Tpi35 won't power on
- Thread starter ItsDaPope
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil. -
Super Cedar firestarters 30% discount Use code Hearth2024 Click here
Similar threads
