Harman P61-2 New Combustion Blower goes limp!

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
  • Super Cedar firestarters 30% discount Use code Hearth2024 Click here
D

dendiggity

Member
Oct 13, 2015
15
Revelstoke
Old combustion blower 1.75 amp never wavered in RPM. New combustion blower (Pellethead .95 amp) starts up at a proper RPM then after a couple minutes it goes limp, i.e. decreases in RPM very significantly. Meanwhile the stove now chews way more than a bag / 24 hr when it didn't previously. I can coax the combustion blower to get back up to speed by putting the stove in test mode. Pressure switch bypassed. ESP cleaned, black wire, dipswitch 5 off, etc...

Help appreciated!
 
You must log in or register to reply here.

Similar threads

B
Harman P61-A 3 blink code and won't turn off
Replies
4
Views
2K
The Pellet Mill - Pellet and Multifuel Stoves
Mrbonesd
M
P
Harman P61 distribution blower noise
Replies
8
Views
7K
The Pellet Mill - Pellet and Multifuel Stoves
Tonyray
Tonyray
P
  • Locked
Harman P61-2 3 Blink Status, Feeder Motor won't run in Test Mode
Replies
3
Views
4K
The Pellet Mill - Pellet and Multifuel Stoves
bogieb
bogieb
L
  • Locked
Breckwell P2000I Low Primary Air Flow Through Burnpot
Replies
0
Views
1K
The Pellet Mill - Pellet and Multifuel Stoves
LarryDS
L
Honda
  • Locked
Harman p61-a (10 yrs old) new circuit board question
Replies
12
Views
3K
The Pellet Mill - Pellet and Multifuel Stoves
Honda
Honda
Top Bottom