Is there an easier way to get to the part other than removing the blower motor?
Does the side of the stove come off?
Does the side of the stove come off?
Changing the igniter on a Whitfield profile 20
- Thread starter kcjosz
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil. -
Super Cedar firestarters 30% discount Use code Hearth2024 Click here
- Status
Is your stove a Freestanding or insert? Do you have the manual for the stove , if not do a search on lennox hearth products and down load the manual.
Free standing and I do have the manual but it doesn't show much.
Troubleshooting only says to call service. I already ordered the part and received it.
This weekends project
!
I'll let you know how it goes....
Troubleshooting only says to call service. I already ordered the part and received it.
This weekends project
!I'll let you know how it goes....
kcjosz said:
No need to remove blower motor.
Just take the allen screw on the auger out enough to pull that part off.
Spray the threads of the ignitor with PB Blaster, Take a crows foot socket and an extension and remove the ignitor.
Ok, just finished......the side does swing open and I removed the blower (only 4 nuts) and that made it very accessible.
Not too bad.
Didn't see your post until I was done.
Up and running!!
Not too bad.
Didn't see your post until I was done.
Up and running
!!- Status
Similar threads
