I have been running this stove for a couple of months without problems, but the past couple of mornings I am having issues at startup. Yesterday, the burnpot overfilled with pellets but did not light. Got a 6-blink status so I reset and tried again. Pellets continued to feed for several minutes but finally got started and ran fine all day. This morning also 6-blink status. Stove is always on room temp setting but did not re-start on its own. Reset status light and the auger feed only enough pellets to start the burn but stopped, again with 6-blink status. Tried that twice then I switch to stove temp mode and was able to run the stove.
Any ideas whats going on or should I just call my dealer for service?
Any ideas whats going on or should I just call my dealer for service?
