quadrafire 1200

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
  • Hope everyone has a wonderful and warm Thanksgiving!
  • Super Cedar firestarters 30% discount Use code Hearth2024 Click here
  1. D

    Help with Control Board for Quadrafire Classic Bay 1200 insert

    First post all, thanks for your patience and welcome (having a bit of a rough morning, found out my main furnace isn't working this morning, either!) This morning my replacement exhaust blower mower arrived for my 16 yr old former exhaust blower (original OEM, not too bad of a life!) that was...
  2. M

    Cb1200 quadrafire not staying running

    Hey everyone I have a quadrafire cb1200. It won't stay running for extended periods of times. It's clean, the pipes are clean, the pot is clean. When I start it up it starts and runs fine for a few hours. The out of no where shuts down. The hopper is full and there are unburned pellets in the...
  3. J

    Classic Bay 1200

    I have no more ideas...... here is what’s happening: Plug Classic Bay 1200 (blue lights flash and exhaust comes on) Red light goes on (calls for pellets) Pellets drop FIRE Then nothing....fire dies no more pellets drop. I replaced the control board because the other one didn’t even flash...
  4. J

    Classic Bay 1200 Thermocouple

    Has anyone ever replaced a Quadrafire Classic Bay 1200 thermocouple? One of the twisted lines recently snapped under the thermocoupler cover and I wanted to replace both. I know I need to slide the cover over the thermocouple, but I have never replaced the actual thermocouple. Is it a hard...
  5. D

    Exhaust blower shuts off

    i have a cb1200. The exhaust blower shuts off when there is fire or glowing pellets in the pot. But what’s weird is the heat blower is still on. I changed the 3 snap discs,thermocouple,door gasket. I also switched out computer and vacuum switch( I read that on here just to test. I know 3...
  6. U

    exhaust blower won't come on

    I have a quad-ra fire 1200 i insert, 2002. when I turn on the stove ( by turning up the thermostat, or pluging it in at this point ) the call light comes on but the exhaust fan doesn't start. The fan runs (when hooked directly to 120 volts). The auger motor runs when I jump the vacuum switch...
  7. H

    snap disk question on classic bay 1200i

    So the snap disk on the right side (looking at the stove) which controls the convection fan....sometimes the fan cuts off and I have to loosen the wing nut and move the disk a little to get the fan on. Is this a sign its going bad? Its pretty random but all I have to do is move it a very...
  8. forrest 17724

    Quadrafire Classic Bay pellet stove won't light

    I have a quadrafire classic bay 1200. the heating element wont get hot. I have replaced the element with a new one. if you start a fire by hand, the stove functions normaly. I haven't run across a post with this sort of a situation.. looking for some guidance. thanks everyone!
  9. M

    Quadrafire 1200

    I have an older Quadrafire 1200.I had a problem with one of the baffle plates. Namely, one of the inside hooks that hang it in front of the heat exchanger tubes broke off. I ordered a replacement from Quadrafire and received it yesterday. The plate I received is not identical to what I have. The...
Top Bottom