heat shield

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
  • Hope everyone has a wonderful and warm Thanksgiving!
  • Super Cedar firestarters 30% discount Use code Hearth2024 Click here
  1. Chopernator

    Ideal Steel wood stove problem

    I have an ideal steel wood stove started burning in the winter of 2022. Cleaning out the stove noticed I had some bracket support bolts missing on the sides 2 on one and 1 on the other and the rest of them were all loose. Upon further inspection noticed something white through the holes of the...
  2. M

    Creosote behind chimney wall?

    I have a question for the group. I have a wood burning fireplace that has a lot of glazed creosote that basic sweeping couldn’t cleanse. A inspection was done and they thought they could see some mortar cracks & holes but hard to tell with all the creosote. I have been given two conflicting...
  3. P

    What material can I have behind a vented Heat Shield in an alcove?

    I have an older (1990s) Patriot stove. The previous owners of the cabin moved it so they could put a stairway where it used to be. They slid it into this alcove and left it. I am looking to reconnect it and use it in the alcove. Looking at the clearance requirements, I should be ok using a...
  4. O

    Ashford 25 blaze king heat shield

    Hi all, we purchased an Ashford 25 blaze king and we’ve had unfortunately nothing but problems. It’s a beautiful stove, but the rheostat shorted on us and needed to be replaced, the bolt that attaches the lower cover became un- welded so we can’t currently reattach it, and now having problems...
    • osummers
    • Thread
    • ash cleaning blaze king ashford 20/30 combusters heat shield
    • Replies: 3
    • Forum: Blaze King
  5. N

    Corner install heat shield requirements

    Hey all, looking to do a corner install with heat shield for a Drolet Nano. Stove only needs 2.5inch clearance to combustable with heat shield installed. I'll be doing 4in to give a bit of extra. How far along the wall do I need to run the heat shield? And which point to I measure off...
  6. U

    Air gap wall/heat shield wall Lopi 1750

    My Lopi 1750 is on the way. i had to take out my old hearth pad and stone that was on the wall and put down some tiles etc. I was about to fix up the wall where the wall stone used to be and found brittle drywall. I’ll be replacing the bad area, but I’m pretty freaked out by what I found. It...
  7. D

    Ok to make a heat shield for the stove rather than the wall?

    Hello, I am working on installing a Trolla 107a that's in good condition. I need to mount it so one side is facing the room and the other side is about 13" from the wall. Rather than mounting a huge heat shield one inch from the wall, can I bolt a smaller one to the stove? I would leave room...
  8. O

    Need heat shield advice. Copper shield for wood walls?

    Hi! I was hoping some folks may have some input on some questions I have before installing my woodstove. I am going to be installing The Hobbit woodstove in my tiny house. The woodstove requires 18 inches of clearance to the rear and 16 for the sides. I have built a wooden stove stand for it to...
Top Bottom