Recent Activity

Activity stream for all registered members at Hearth.com Forums Home.

  1. woodey replied to the thread Plans finally coming together.

    Thanks for your service and good luck on the rest of your project!

    Jul 17, 2019 at 9:08 PM
  2. wagne223 attached a file to the thread New member introduction.

    Pic of stove in place. [ATTACH]

    43b5933e8e8c10fb42eda079b5603924.jpg Jul 17, 2019 at 7:49 PM
  3. wagne223 replied to the thread New member introduction.

    Copy that begreen, thanks! I read all the threads in the "read me first" section. The 2 main points veteran burners bring up is the...

    Jul 17, 2019 at 7:47 PM
  4. wagne223 attached a file to the thread New member introduction.

    Exterior pics of rear of house and close up of chimney. [ATTACH][ATTACH]

    6edffa4f8881d1b5fb3aa50e882d2685.jpg de86e24be456a5c7e1679a15945829fa.jpg Jul 17, 2019 at 7:45 PM
  5. wagne223 replied to the thread New member introduction.

    Copy that! Sent from my SM-G892A using Tapatalk

    Jul 17, 2019 at 7:43 PM
  6. wagne223 replied to the thread New member introduction.

    One thing I did pick up reading on this board is the moisture content. With an open fireplace, any wood I purchased did just fine,...

    Jul 17, 2019 at 7:43 PM
  7. blades replied to the thread Best way to make kindling.

    black powder?

    Jul 17, 2019 at 7:04 PM
  8. blades replied to the thread New member introduction.

    and if they say it is kiln dried ask how long it was in the kiln and at what temp. 2-3 hours is not going to do much except, perhaps,...

    Jul 17, 2019 at 7:03 PM
  9. Woody Stover attached a file to the thread Best way to make kindling.

    I get some easy-splitting stuff like Tulip Poplar or Red Maple, then use a maul to get it small enough to handle with the Estwing...

    001.JPG Jul 17, 2019 at 4:29 PM
  10. missing link replied to the thread Smoke Dragon to P61.

    Yup, I figure ill stick with manual ignight for the upcoming season. I haven't got into the inards of the stove yet but that will...

    Jul 17, 2019 at 3:14 PM
Loading...