Work Done in 2019

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Had a nice drop of ash delivered last week. Amounted to a face cord after being split and stacked. That completes my first full cord of 2022 wood.

I top covered this weekend too for this season’s splits. About 4 cords.
 
Had a nice drop of ash delivered last week. Amounted to a face cord after being split and stacked. That completes my first full cord of 2022 wood.

I top covered this weekend too for this season’s splits. About 4 cords.
How much do you usually burn when your area has a very cold winter?
 
How much do you usually burn when your area has a very cold winter?

I am consistently in between 3-1/2 to 4-1/2 full cords every year for the last 7 years. Each of my racks (holding 1 year worth) holds four (4ish) cords. They are 32 feet long and stacked 3 splits deep. Probably closer to 5 foot high instead of 4. So maybe there is 4 1/2 - 5 cords in each rack. I have yet to completely empty a rack in those 7 years.

You can see in the photo where I removed 1 cord for the start of the season and replaced it with the 2022 wood I referenced above.

How about you guys?
 

Attachments

  • 1AF67B03-C030-4E3C-B1F5-5B2CE1C6D45F.png
    1AF67B03-C030-4E3C-B1F5-5B2CE1C6D45F.png
    446.1 KB · Views: 255
I am consistently in between 3-1/2 to 4-1/2 full cords every year for the last 7 years. Each of my racks (holding 1 year worth) holds four (4ish) cords. They are 32 feet long and stacked 3 splits deep. Probably closer to 5 foot high instead of 4. So maybe there is 4 1/2 - 5 cords in each rack. I have yet to completely empty a rack in those 7 years.

You can see in the photo where I removed 1 cord for the start of the season and replaced it with the 2022 wood I referenced above.

How about you guys?
We usually burn around 4.34 full cord of hardwood and 1.86 full cord of shoulder season wood. We started burning white pine or hemlock from all the wind damage we had.

Our stacks are 16 feet long and four feet high, each stack should be .62 of a cord. Our rows have 15 to 16 inches between them with most stacking areas holding 3.10 full cord.

Our wood stove is in the basement so we burn more, we usually start burning Sept. 15 unless the temperature is still warm out.
 
Last edited:
  • Like
Reactions: heavy hammer
This summer is going fast. We are planning on finishing another wall of siding this week. The cedar should go a little faster, except for all the cuts on the gable ends.
 
This summer is going fast. We are planning on finishing another wall of siding this week. The cedar should go a little faster, except for all the cuts on the gable ends.
We're getting a nice rain this morning with a bunch of rumbling going on. With school just around the corner in our area, summer is almost done but September can be nice or just real wet in this area.
 
We usually burn around 4.34 full cord of hardwood and 1.86 full cord of shoulder season wood. We started burning white pine or hemlock from all the wind damage we had.

Our stacks are 16 feet long and four feet high, each stack should be .62 of a cord. Our rows have 15 to 16 inches between them with most stacking areas holding 3.10 full cord.

Our wood stove is in the basement so we burn more, we usually start burning Sept. 15 unless the temperature is still warm out.


We will usually start burning around mid October. That’s usually based upon my excitement to get that first firewood going. Our real burning season and need for it usually Halloween time to the end of March/early April.

I still have a few chores on the list before that first fire. Clean the liner, check the fire brick and gaskets. May replace the door glass as it has some staining that seems to be burnt in. I’m afraid to change the glass for only aesthetics because I have heard stories of screws stripping out and don’t want to cause more work and money than need be.
 
I usually start burning around the same time Bushels20, mid Oct. We usually run the furnace for a week or so but when we get one of those cold rainy weekends I usually fire up the basement stove once I have had enough with being chilled.
 
We had a bunch of dead pine that I felled, once the dead stuff was down I felled a pine into the woods (didn't get a before pick) but once I clean all the chit pine up and then split the good stuff, this new area will give me more room to push the snow.

In the past when we would get lots of snow all winter, this area near the driveway could get pretty narrow so I would move the snow, that shouldn't happen anymore.
 

Attachments

  • 101_9511.JPG
    101_9511.JPG
    378.2 KB · Views: 239
  • 101_9512.JPG
    101_9512.JPG
    180 KB · Views: 230
  • 101_9513.JPG
    101_9513.JPG
    332.3 KB · Views: 237
Not cord wood but...


Took a drive to the Homefire plant for a tote of “seconds”. Perhaps close to a ton. It made the old 3/4 ton Rustarado squat.

Moving it twice wasn’t fun. It was cheap though.
 

Attachments

  • E6B4658B-9748-4984-BF57-0F084C834610.jpeg
    E6B4658B-9748-4984-BF57-0F084C834610.jpeg
    159.3 KB · Views: 244
  • 42B48048-C14F-41ED-9CE9-AFFC8B7EC361.jpeg
    42B48048-C14F-41ED-9CE9-AFFC8B7EC361.jpeg
    215.2 KB · Views: 253
Not cord wood but...


Took a drive to the Homefire plant for a tote of “seconds”. Perhaps close to a ton. It made the old 3/4 ton Rustarado squat.

Moving it twice wasn’t fun. It was cheap though.

I wouldn't mind coming across a deal like that! Even the tote would be worth it for me.
 
I felled another pine in the area I've been working, I cut,split the better pine and then moved it to the pile. This will be a walking trail and a new spot for plowing the snow this winter.
 

Attachments

  • 101_9518.JPG
    101_9518.JPG
    271 KB · Views: 245
  • 101_9519.JPG
    101_9519.JPG
    277.3 KB · Views: 234
  • 101_9520.JPG
    101_9520.JPG
    233.3 KB · Views: 234
  • 101_9521.JPG
    101_9521.JPG
    253.8 KB · Views: 225
  • 101_9522.JPG
    101_9522.JPG
    275 KB · Views: 233
  • 101_9524.JPG
    101_9524.JPG
    248.4 KB · Views: 238
  • 101_9526.JPG
    101_9526.JPG
    297.4 KB · Views: 229
  • 101_9525.JPG
    101_9525.JPG
    248.4 KB · Views: 220
I'll post some pics of the siding today.
 
There are still a few pieces of siding above the window that need to be stained then I'll have it all up on the wall. The trim has all been primed and waiting for paint and only one batten needs to be stained (miscounted originally). The second floor will be getting cedar shingles and we plan on flaring and weaving them at the bottoms and corners.
 

Attachments

  • DSCF0515.JPG
    DSCF0515.JPG
    497.3 KB · Views: 230
  • DSCF0519.JPG
    DSCF0519.JPG
    182.2 KB · Views: 217
I am curious how much wood does that boiler use in a season?
Nice Shed
 
9815d78e2c6ab99845922990c41f734a.jpg 22ae7b6dca7f88be0aeae6a09f9e4323.jpg b4693459508f4d99d36b4a7c2066b763.jpg e8975db44f95145e9945aa1be56ac18f.jpg 5aebae0a97eb6790c916992866957fe2.jpg bb2278ff7840a790ef89366afc6c436b.jpg
Primary loop built and installed in basement. Have it pressurized with well pressure right now no leaks so far. Too the time to add a outside faucet on the back of the house when I plumbed in the fill.

Still have to install the heat exchangers and the secondary pumps and the heaters in the basement and the garage.


Sent from my iPhone using Tapatalk
 
Last edited by a moderator:
Even though it rained all day, I did get some stacking in but I'm wondering if they're stacked a bit tight.
 

Attachments

  • IMG_9532.JPG
    IMG_9532.JPG
    174.9 KB · Views: 198
  • IMG_9533.JPG
    IMG_9533.JPG
    231.4 KB · Views: 195
  • IMG_9534.JPG
    IMG_9534.JPG
    230.3 KB · Views: 214