The Chimney Sweep Online Fireplace, Woodstove, Gas Stove and Barbecue Shop
STOVE DIMENSIONS: 25 1/2" WIDE X 25" DEEP X 30" TALL CONNECTOR PIPE USED: 6" SINGLE-WALL OR DOUBLE-WALL STOVEPIPE HEARTH (FLOOR PROTECTION) REQUIREMENT: ANY 1/4" NON-COMBUSTIBLE MATERIAL MINIMUM HEARTH EXTENSION FROM REAR OF STOVE: 0" MINIMUM HEARTH EXTENSION FROM SIDES OF STOVE: 6" MINIMUM HEARTH EXTENSION FROM DOOR OF STOVE: 16"
FLAT WALL INSTALLATIONS: | Series A s/n < 440,000 | Series B s/n > 440,000 | CORNER INSTALLATIONS: | Series A s/n < 440,000 | Series B s/n > 440,000 | |
A: STOVE TO BACKWALL: SINGLE-WALL STOVEPIPE DOUBLE-WALL STOVEPIPE MOBILE HOME W/ DOUBLE WALL PIPE | 9" 6" 7" | 9" 7-1/2" 10" | G: STOVE TO CORNER WALLS: SINGLE-WALL STOVEPIPE DOUBLE-WALL STOVEPIPE MOBILE HOME W/ DOUBLE WALL PIPE | 4" 4" 5" | 6" 5" 8" | |
B: STOVE TO SIDEWALL: SINGLE-WALL STOVEPIPE DOUBLE-WALL STOVEPIPE MOBILE HOME W/ DOUBLE WALL PIPE | 12" 12" 14" | 14" 13" 18" |
H: CENTERLINE PIPE TO CORNER
WALLS: SINGLE-WALL STOVEPIPE DOUBLE-WALL STOVEPIPE MOBILE HOME W/ DOUBLE WALL PIPE | 18-3/4" 18-3/4" 19-3/4" | 20-3/4" 19-3/4" 22-3/4" | |
C: CENTERLINE PIPE TO BACKWALL: SINGLE-WALL STOVEPIPE DOUBLE-WALL STOVEPIPE MOBILE HOME W/ DOUBLE WALL PIPE | 17-1/2" 14-1/2" 15-1/2" | 17-1/2" 16" 18-1/2" |
I: DIAGONAL, CORNER TO FRONT EDGE: SINGLE-WALL STOVEPIPE. DOUBLE-WALL STOVEPIPE MOBILE HOME W/ DOUBLE WALL PIPE | 59" 59" 61" | 61-3/4" 60-1/3" 64-1/2: | |
D: CENTERLINE PIPE TO SIDEWALL: SINGLE-WALL STOVEPIPE DOUBLE-WALL STOVEPIPE MOBILE HOME W/ DOUBLE WALL PIPE | 24-3/4" 24-3/4" 26-3/4" | 26-3/4" 25-3/4" 30-3/4" |
J: CORNER TO EDGE OF HEARTH: SINGLE-WALL STOVEPIPE DOUBLE-WALL STOVEPIPE MOBILE HOME W/ DOUBLE WALL PIPE | 56" 56" 57" | 56-3/4 55-3/4 58-3/4 | |
E: MINIMUM HEARTH WIDTH: | 36" | 36" | L: HEARTH WIDTH AT 16" FROM DOOR: | 36" | 36" | |
F: BACKWALL TO FRONT OF HEARTH: SINGLE-WALL STOVEPIPE DOUBLE-WALL STOVEPIPE MOBILE HOME W/ DOUBLE WALL PIPE | 50" 47" 48" | 50" 48-1/2" 51" |
COMBUSTIBLE ALCOVE DIMENSIONS: | 55-1/2" Wide 84" Tall 48" Deep |
57-1/2" Wide 84" Tall 48" Deep |
OUTSIDE AIR SUPPLIED FROM VENTILATED CRAWLSPACEInstall a length of 4" rigid or flexible aluminum intake pipe down through a 4-1/8" hole in the floor anywhere under the pedestal, extending below the floor joists and insulation. The intake pipe doesn't attach directly to the stove: snip and flare the pipe at the top to hold it in place. Use silicone cement to glue a piece of 1/4" wire rodent mesh at the bottom. | OUTSIDE AIR SUPPLIED THROUGH BACKWALLRemove the air intake cover from the back of the pedestal and insert a length of 4" rigid or flexible aluminum intake pipe extending through 4-1/8" hole in outside wall behind the stove. Attach a standard 4" dryer vent termination on the outside of the wall, removing the flapper plate and substituting a piece of 1/4" rodent mesh silicone-cemented in place. |
OUTSIDE AIR SUPPLIED FROM VENTILATED CRAWLSPACEInsert a length of 4" rigid or flexible aluminum intake pipe into the knockout hole in the bottom of the air plenum and extend it down through a 4-1/8" hole in the floor, terminating below the floor joists and insulation. Caulk around the intake pipe where it penetrates the floor and use silicone cement to glue a piece of 1/4" wire rodent mesh to the bottom. | OUTSIDE AIR SUPPLIED THROUGH BACKWALLInsert a length of 4" rigid or flexible aluminum into the knockout hole in the rear of the air plenum and run back through a 4-1/8" hole in the outside wall behind the stove. Attach a standard 4" dryer vent termination on the outside of the wall, removing the flapper plate and substituting a piece of 1/4" rodent mesh silicone-cemented in place. |