The Chimney Sweep Online Fireplace, Woodstove, Gas Stove and Barbecue Shop
STOVE DIMENSIONS: 19-7/8" W (front) x 11-7/8" W (rear) x 17-3/8" D x 41-3/4" T CONNECTOR PIPE USED: 6" SINGLE-WALL OR DOUBLE-WALL STOVEPIPE
HEARTH (FLOOR PROTECTION) REQUIREMENTS:
MATERIAL: ANY SOLID, CONTINUOUS, NON-COMBUSTIBLE MATERIAL
MINIMUM HEARTH EXTENSION FROM REAR OF STOVE............ 0"
MINIMUM HEARTH EXTENSION FROM SIDES OF STOVE....... 4-1/2"
MINIMUM HEARTH EXTENSION FROM LOADING DOOR OF STOVE... 16"
|
|
A: STOVE TO BACKWALL: SINGLE-WALL PIPE........... 12" DOUBLE-WALL PIPE......... 7" | G: STOVE TO CORNER WALLS: SINGLE-WALL PIPE........... 11" DOUBLE-WALL PIPE......... 11" |
B: STOVE TO SIDEWALL: SINGLE-WALL PIPE........... 15" DOUBLE-WALL PIPE......... 15" | H: CENTERLINE PIPE TO CORNER WALLS: SINGLE-WALL PIPE........... 20-1/2" DOUBLE-WALL PIPE......... 20-1/2" |
C: CENTERLINE PIPE TO BACKWALL: SINGLE-WALL PIPE........... 20-1/2" DOUBLE-WALL PIPE......... 14-1/2" | I: DIAGONAL CORNER TO FRONT LOP: SINGLE-WALL PIPE........... 53" DOUBLE-WALL PIPE......... 53" |
D: CENTERLINE PIPE TO SIDEWALL: SINGLE-WALL PIPE........... 25" DOUBLE-WALL PIPE......... 25" | COMBUSTIBLE ALCOVE DIMENSIONS: DOUBLE-WALL PIPE ONLY MINIMUM 50" WIDE X 68" TALL MAXIMUM 48" DEEP |
E: MINIMUM HEARTH WIDTH: SINGLE-WALL PIPE........... 28-3/4" DOUBLE-WALL PIPE......... 28-3/4" | |
F: BACKWALL TO FRONT OF HEARTH: SINGLE-WALL PIPE........... 43-3/8" DOUBLE-WALL PIPE......... 38-3/8" |
OUTSIDE AIR SUPPLIED FROM CRAWLSPACEBolt optional outside air adapter to stove at bottom rear. Attach a length of 3" rigid or flexible aluminum pipe to the intake collar with a 3" pipe clamp, then elbow down through a 3-1/8" hole in the floor behind the stove, extending the pipe below the floor joists and insulation. Caulk around the pipe where it penetrates the floor and use silicone cement to glue on a piece of 1/4" wire rodent mesh at the bottom. | OUTSIDE AIR SUPPLIED THROUGH BACKWALLBolt optional outside air adapter to stove at bottom rear. Attach a length of 3" rigid or flexible aluminum intake pipe to the intake collar with a 3" pipe clamp, extend through a 3-1/8" hole in the outside wall behind the stove. Attach a standard 3" dryer vent termination on the outside of the wall, removing the flapper plate and substituting a piece of 1/4" rodent mesh silicone-cemented in place. |