The Chimney Sweep Online Fireplace, Woodstove, Gas Stove and Barbecue Shop
STOVE DIMENSIONS: 19-1/2" DIAMETER X 41-1/2" TALL CONNECTOR PIPE USED: 6" SINGLE-WALL OR DOUBLE-WALL STOVEPIPE NOTE: USE OF DOUBLE-WALL STOVEPIPE DOES NOT REDUCE BARI CLEARANCES
THE BARI MAY BE INSTALLED TWO WAYS: ROTATING MODE: STOVE CAN BE ROTATED 180º INTO 13 DIFFERENT LOCKED POSITIONS PERMANENTLY LOCKED MODE: NO ROTATION; STOVE DOOR FACES STRAIGHT FORWARD ONLY
HEARTH (FLOOR PROTECTION) REQUIREMENTS: MATERIAL: ANY SOLID, CONTINUOUS, NON-COMBUSTIBLE MATERIAL MINIMUM HEARTH EXTENSION FROM REAR OF STOVE IN LOCKED MODE........ 2" MINIMUM HEARTH EXTENSION FROM REAR OF STOVE IN ROTATING MODE...... 6" MINIMUM HEARTH EXTENSION FROM SIDES OF STOVE IN LOCKED MODE... 4-1/2" MINIMUM HEARTH EXTENSION FROM SIDES OF STOVE IN ROTATING MODE.... 16" MINIMUM HEARTH EXTENSION FROM LOADING DOOR OF STOVE.............. 16"
|
|
A: STOVE TO BACKWALL: STOVE IN LOCKED MODE........... 7" STOVE IN ROTATING MODE..... 17" | G: STOVE TO CORNER WALLS: LOCKED MODE ONLY... 12" |
B: STOVE TO SIDEWALL: STOVE IN LOCKED MODE......... 17" STOVE IN ROTATING MODE..... 38" | H: CENTERLINE PIPE TO CORNER WALLS: LOCKED MODE ONLY... 21-3/4" |
C: CENTERLINE PIPE TO BACKWALL: STOVE IN LOCKED MODE....... 16.5" STOVE IN ROTATING MODE... 26.5" | I: DIAGONAL CORNER TO FRONT LOP: LOCKED MODE ONLY... 54" |
D: CENTERLINE PIPE TO SIDEWALL: STOVE IN LOCKED MODE....... 26.5" STOVE IN ROTATING MODE... 47.5" | COMBUSTIBLE ALCOVE DIMENSIONS: LOCKED MODE ONLY MINIMUM 46" WIDE X 84" TALL MAXIMUM 48" DEEP |
E: MINIMUM HEARTH WIDTH: STOVE IN LOCKED MODE......... 28" STOVE IN ROTATING MODE..... 51" | |
F: BACKWALL TO FRONT OF HEARTH: STOVE IN LOCKED MODE......... 40" STOVE IN ROTATING MODE..... 50" |
OUTSIDE AIR SUPPLIED FROM CRAWLSPACEBolt optional outside air adapter to stove at bottom rear. Attach a length of 3" rigid or flexible aluminum pipe to the intake collar with a 3" pipe clamp, then elbow down through a 3-1/8" hole in the floor behind the stove, extending the pipe below the floor joists and insulation. Caulk around the pipe where it penetrates the floor and use silicone cement to glue on a piece of 1/4" wire rodent mesh at the bottom. | OUTSIDE AIR SUPPLIED THROUGH BACKWALLBolt optional outside air adapter to stove at bottom rear. Attach a length of 3" rigid or flexible aluminum intake pipe to the intake collar with a 3" pipe clamp, extend through a 3-1/8" hole in the outside wall behind the stove. Attach a standard 3" dryer vent termination on the outside of the wall, removing the flapper plate and substituting a piece of 1/4" rodent mesh silicone-cemented in place. |